Upper and lower limits of analog input values are set to 20 and 0 ,
had everything normal, in the absence of the analog signal access , the
software displays a value of 0 , there is signal Nanda plc digital input module access
, they also have a normal display, but under normal use two or three
days , the upper and lower limits remain unchanged, the analog input
value in the absence of wiring is 6.8 , all the channels I have tried
are 6.8 , then the company gave me a new simulation input module ,
installed after the beginning is normal, but it is the same problem in a
couple of days later , I ask an expert what causes ?
Also this PLC as well as a relay output module , 2, 3 and 4-channel connection of solenoid valves, found often there will be Nanda micro smart plc a
problem , sometimes when I start solenoid valve, status lights all of a
sudden relay output modules are extinguished , the network does not
pass , after a minute or so , PLC will automatically linked to the
network, the solenoid valve to start this and what is the reason ? I
have checked the wiring before , are not the problem
You said power module before Nanda modular plc I
checked, input 220V, power module output is 5.09V, I then adjust it to
5.01V, it should be no problem , there is nothing good advice.
没有评论:
发表评论