Restart the computer Cause Solution:
1, there may be a BIOS settings problem, restore the default settings into the BIOS or the motherboard battery out, Flip, discharge. Objective: To restore the default settings for the BIOS values, excluding the BIOS default automatic restart or shutdown cooling phenomenon.
2, the restart occurs before the restart occurs if the application software or download software to run the program, then restart the plc controller suppliers software may be caused, in general the program to uninstall and re-install the software, if the fault persists, then the software itself is wrong, you can not to use.
3, anti-virus software in Safe Mode using viruses, troubleshooting if the restart, restart the failure is caused by a virus.
4, boot into safe mode by pressing F8 after the exit in normal mode. Also available system comes with System Restore feature to restore, if the restart troubleshooting, restart the system file damage is caused.
5, if the fault persists, then check the power supply, power quality is poor, aging or power is too small to meet the power needs of the various parts of a computer, high-quality power supply can be replaced, if troubleshooting is to restart the power failure caused.
6, a device restart when hot-plug if the computer going on, according to the first three resolved.
7, then use the process of elimination, check memory, video card, CPU, CPU fan, motherboard, etc.
8, check the memory, memory low quality, poor Nanda industrial automation plc cooling, overclocking, different brands of memory mixed interpolation and CAS setting too low can cause the computer to restart, test method can be used to replace the memory, and memory in the BIOS parameters are adjusted accordingly .
9, check the motherboard, motherboard aging, capacitor failure or exploding, motherboard and chassis backplane can be caused by a short circuit, etc. reboot, you can remove the motherboard from the chassis to inspect or test, then check the CPU heatsink fan base silicone is dry, If dry, the CPU fan on silica gel to clean and re-coated with silicone to good. Then check the CPU fan rotation, and the CPU temperature is normal.
10, cleaning method: a host computer through the Nanda cpu module plc dust components to be cleaned troubleshooting methods. Dust is also caused by one computer to automatically restart failed factors, dust can cause aging of components, pin oxidation, poor contact and short circuit faults. For dust caused by these failures, the general use of more effective cleaning method.
没有评论:
发表评论