2014年3月3日星期一

Some problems plc analog output modules in

Upper and lower limits of analog input values ​​are set to 20 and 0 , had everything normal, in the absence of the analog signal access , the software displays a value of 0 , there is signal Nanda plc digital input module  access , they also have a normal display, but under normal use two or three days , the upper and lower limits remain unchanged, the analog input value in the absence of wiring is 6.8 , all the channels I have tried are 6.8 , then the company gave me a new simulation input module , installed after the beginning is normal, but it is the same problem in a couple of days later , I ask an expert what causes ?
Also this PLC as well as a relay output module , 2, 3 and 4-channel connection of solenoid valves, found often there will be  Nanda micro smart plc a problem , sometimes when I start solenoid valve, status lights all of a sudden relay output modules are extinguished , the network does not pass , after a minute or so , PLC will automatically linked to the network, the solenoid valve to start this and what is the reason ? I have checked the wiring before , are not the problem
You said power module before Nanda modular plc  I checked, input 220V, power module output is 5.09V, I then adjust it to 5.01V, it should be no problem , there is nothing good advice.

没有评论:

发表评论